DataSheet39.com

What is TEA1732CTS?

This electronic component, produced by the manufacturer "NXP Semiconductors", performs the same function as "GreenChip SMPS control IC".


TEA1732CTS Datasheet PDF - NXP Semiconductors

Part Number TEA1732CTS
Description GreenChip SMPS control IC
Manufacturers NXP Semiconductors 
Logo NXP Semiconductors Logo 


There is a preview and TEA1732CTS download ( pdf file ) link at the bottom of this page.





Total 20 Pages



Preview 1 page

No Preview Available ! TEA1732CTS datasheet, circuit

TEA1732CTS
GreenChip SMPS control IC
Rev. 1 — 18 March 2014
Product data sheet
1. General description
The TEA1732CTS is a low cost Switched Mode Power Supply (SMPS) controller IC
intended for flyback topologies. The TEA1732CTS operates in peak current and
frequency control mode. Frequency jitter has been implemented to reduce
ElectroMagnetic Interference (EMI). Slope compensation is integrated for Continuous
Conduction Mode (CCM) operation.
The TEA1732CTS IC features OverPower Protection (OPP). The controller accepts an
overpower situation for a limited amount of time.
Mains undervoltage protection (brownout), output OverVoltage Protection (OVP), and
OverTemperature Protection (OTP) can be implemented using a minimal number of
external components.
At low-power levels, the primary peak current is set to 25 % of the maximum peak current.
The switching frequency is reduced to limit the switching losses. The combination of fixed
frequency operation at high output power and frequency reduction at low output power
provides high efficiency over the total load range.
The TEA1732CTS makes the design of low-cost, highly efficient and reliable supplies for
power requirements up to 75 W easier by requiring a minimum number of external
components.
2. Features and benefits
SMPS controller IC enabling low-cost applications
Large input voltage range (12 V to 30 V)
Integrated OverVoltage Protection (OVP) on the VCC pin
Accurate OverVoltage Protection (OVP) via the ISENSE pin
Very low supply current during start-up and restart (10 A typical)
Low supply current during normal operation (0.58 mA typical without load)
Internal overpower time-out
Overpower protection or high/low line compensation
Fixed switching frequency with frequency jitter to reduce EMI
Frequency reduction with fixed minimum peak current to maintain high efficiency at
low output power levels
Frequency increase at peak power operation
Slope compensation for CCM operation
Integrated soft-start

line_dark_gray
TEA1732CTS equivalent
NXP Semiconductors
TEA1732CTS
GreenChip SMPS control IC
UHFWLILHG
PDLQV
EURZQLQ
9&&
3527(&7
9VWDUWXS
9WK 89/2
9GHW 3527(&7
,6(16(
VRIWVWDUW
RXWSXWYROWDJH
RXWSXWORDG
FKDUJLQJ9&&
FDSDFLWRU
VWDUWLQJ
FRQYHUWHU
QRUPDO
RSHUDWLRQ
UHVWDUW
GHOD\
RYHUSRZHU
WLPHRXW
UHVWDUW
Fig 4. Start-up sequence, normal operation and restart sequence
PD[LPXPORDG
DDD
When the voltage on pin VCC drops below the Vth(UVLO) level during normal operation, the
controller stops switching. The TEA1732CTS waits for the rectified mains to charge the
VCC pin using resistor R1.
7.3 Supply management
All internal reference voltages are derived from a temperature compensated on-chip band
gap circuit. Internal reference currents are derived from a trimmed and temperature
compensated current reference circuit.
7.4 External overtemperature protection and mains detect input
(pin PROTECT)
The PROTECT input combines the functions of the external OverTemperature Protection
(OTP) and the mains voltage detection. An internal clock separates the period of
measuring the mains voltage and the period of detecting external OverTemperature
Protection (OTP). In a typical application, the PROTECT pin is connected to the mains via
a resistor. It is connected to ground via a negative temperature coefficient (NTC)
thermistor and a diode.
TEA1732CTS
Product data sheet
When measuring the mains voltage, the PROTECT pin is regulated to 0.25 V so that the
external diode does not conduct any current. The current into the PROTECT pin is
measured and stored. Once the measured current is above the brownin level, the system
is allowed to start switching. If the mains voltage is continuously below the brownout level
for at least 32 ms, a brownout is detected. The system immediately stops switching and
performs a restart. The VCC capacitor is discharged to the UVLO level and then charged
to Vstartup once before switching recommences (See Figure 5).
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 18 March 2014
© NXP Semiconductors N.V. 2014. All rights reserved.
5 of 20


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for TEA1732CTS electronic component.


Information Total 20 Pages
Link URL [ Copy URL to Clipboard ]
Download [ TEA1732CTS.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
TEA1732CTSThe function is GreenChip SMPS control IC. NXP SemiconductorsNXP Semiconductors

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

TEA1     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search