|
|
PDF S220Z1-M02 Data sheet ( Hoja de datos )
| Número de pieza | S220Z1-M02 | |
| Descripción | TFT LCD Module | |
| Fabricantes | CHI MEI | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de S220Z1-M02 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
Global LCD Panel Exchange Center
www.panelook.com
DOC No.:
Issued Date: Mar. 12, 2008
Model No.: S220Z1-M02
Tentative
Specifications
Model No : S220Z1 – M02
Customer :
Approved by :
Note :
Liquid Crystal Display Division
QRA Division.
OA Head Division.
Approval
Approval
1 / 29
Version 0.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page  
Global LCD Panel Exchange Center
www.panelook.com
DOC No.:
Issued Date: Mar. 12, 2008
Model No.: S220Z1-M02
Tentative
Note (1) Please refer to the attached drawings for more information of front and back outline dimensions.
2. ABSOLUTE MAXIMUM RATINGS
2.1 ABSOLUTE RATINGS OF ENVIRONMENT
Item
Storage Temperature
Operating Ambient Temperature
Shock (Non-Operating)
Vibration (Non-Operating)
LCD Cell Life Time
Symbol
TST
TOP
SNOP
VNOP
LCELL
Value
Min.
-20
0
-
-
50,000
Max.
+60
+50
50
1
-
Note (1) Temperature and relative humidity range is shown in the figure below.
(a) 90 %RH Max. (Ta Љ 40 ºC).
(b) Wet-bulb temperature should be 39 ºC Max. (Ta > 40 ºC).
(c) No condensation.
Relative Humidity (%RH)
100
90
80
60
Operating Range
40
20
10 Storage Range
Unit Note
ºC (1)
ºC (1), (2)
G (3), (5)
G (4), (5)
Hrs
MTBF
based
-40 -20
0 20 40
Temperature (ºC)
60 80
Note (2) The temperature of panel display surface area should be 0 ºC Min. and 60 ºC Max.
Note (3) 11ms, half sine wave, 1 time for ± X, ± Y, ± Z.
Note (4) 10 ~ 300 Hz, 10min/cycle, 3 cycles each X, Y, Z.
Note (5) Upon the Vibration and Shock tests, the fixture used to hold the module must be firm and rigid
enough to prevent the module from twisting or bending by the fixture.
5 / 29
Version 0.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page 
Global LCD Panel Exchange Center
www.panelook.com
DOC No.:
Issued Date: Mar. 12, 2008
Model No.: S220Z1-M02
Tentative
The output of the inverter must have symmetrical (negative and positive) voltage waveform and
symmetrical current waveform.(Unsymmetrical ratio is less than 10%) Please do not use the inverter
which has unsymmetrical voltage and unsymmetrical current and spike wave. Lamp frequency may
produce interface with horizontal synchronous frequency and as a result this may cause beat on the
display. Therefore lamp frequency shall be as away possible from the horizontal synchronous
frequency and from its harmonics in order to prevent interference.
Requirements for a system inverter design, which is intended to have a better display performance, a
better power efficiency and a more reliable lamp. It shall help increase the lamp lifetime and reduce its
leakage current.
a. The asymmetry rate of the inverter waveform should be 10% below;
b. The distortion rate of the waveform should be within Ѕ2 ± 10%;
c. The ideal sine wave form shall be symmetric in positive and negative polarities.
* Asymmetry rate:
I p | I p – I –p | / Irms * 100%
I -p * Distortion rate
I p (or I –p) / Irms
11 / 29
Version 0.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet S220Z1-M02.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| S220Z1-M02 | TFT LCD Module | CHI MEI |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |