|
|
Número de pieza | N201J4-L01 | |
Descripción | TFT LCD Module | |
Fabricantes | CHI MEI | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de N201J4-L01 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! Global LCD Panel Exchange Center
www.panelook.com
Doc. No.: 14074327
Issued Date: Dec. 05, 2007
Model No.: N201J4 - L01
Approval
TFT LCD Approval Specification
MODEL NO.: N201J4 - L01
Customer :
Approved by :
Note :
ಖᙕ
ՠ܂
ᐉு
ߡۥ ދป
2007-12-12 PMMD
14:04:41 CST Director
cs_lee(ޕݳᆣ
/56510/44926)
Director Accept
1 / 30
Version 2.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page Global LCD Panel Exchange Center
www.panelook.com
Doc. No.: 14074327
Issued Date: Dec. 05, 2007
Model No.: N201J4 - L01
Approval
2. ABSOLUTE MAXIMUM RATINGS
2.1 ABSOLUTE RATINGS OF ENVIRONMENT
Item
Storage Temperature
Storage Humidity
Operating Ambient Temperature
Operating Humidity
Shock (Non-Operating)
Vibration (Non-Operating)
Symbol
TST
HST
TOP
HOP
HST
VNOP
Value
Min.
-20
10
0
20
-
-
Note (1) Temperature and relative humidity range is shown below.
(a) 90 %RH Max. (Ta Љ 40 ºC).
(b) Wet-bulb temperature should be 39 ºC Max. (Ta > 40 ºC).
(c) No condensation.
Max.
+60
90
+50
90
200/2
1.5
Relative Humidity (%RH)
100
90
80
60
Operating Range
40
20
10 Storage Range
Unit
ºC
%
ºC
%
G/ms
G
Note
(1)
(1), (2)
(3), (5)
(4), (5)
-40 -20
0 20 40 60 80
Temperature (ºC)
Note (2) The ambient temperature means the temperature of panel surface.
Note (3) 1 time for ± X, ± Y, ± Z. for Condition (200G / 2ms) is half Sine Wave.
Note (4) 10 ~ 500 Hz, 0.5 Hr / Cycle, 1 cycles for each X, Y, Z axis.
Note (5) At testing Vibration and Shock, the fixture in holding the module has to be hard and rigid enough
so that the module would not be twisted or bent by the fixture.
The fixing condition is shown as below:
Side Mount Fixing Screw
gap=2mm
LCD Module
Bracket
Side Mount Fixing Screw
Stage
5 / 30
Version 2.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page Global LCD Panel Exchange Center
www.panelook.com
Doc. No.: 14074327
Issued Date: Dec. 05, 2007
Model No.: N201J4 - L01
Approval
The output of the inverter must have symmetrical (negative and positive) voltage waveform and
symmetrical current waveform.(Unsymmetrical ratio is less than 10%) Please do not use the inverter,
which has unsymmetrical voltage and unsymmetrical current and spike wave. Lamp frequency may
produce interface with horizontal synchronous frequency and as a result this may cause beat on the
display. Therefore lamp frequency shall be as away possible from the horizontal synchronous
frequency and from its harmonics in order to prevent interference.
Requirements for a system inverter design, which is intended to have a better display performance, a
better power efficiency and a more reliable lamp. It shall help increase the lamp lifetime and reduce its
leakage current.
a. The asymmetry rate of the inverter waveform should be 10% below;
b. The distortion rate of the waveform should be within Ѕ2 ± 10%;
c. The ideal sine wave form shall be symmetric in positive and negative polarities.
Ip
I -p
* Asymmetry rate:
| I p – I –p | / Irms * 100%
* Distortion rate
I p (or I –p) / Irms
11 / 30
Version 2.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet N201J4-L01.PDF ] |
Número de pieza | Descripción | Fabricantes |
N201J4-L01 | TFT LCD Module | CHI MEI |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |