|
|
PDF OB2283 Data sheet ( Hoja de datos )
| Número de pieza | OB2283 | |
| Descripción | High Performance Current Mode PWM Controller | |
| Fabricantes | On-Bright Electronics | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de OB2283 (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
|
No Preview Available !
OB2283
High Performance Current Mode PWM Controller
GENERAL DESCRIPTION
OB2283 is a highly integrated current mode PWM
control IC optimized for high performance, low
standby power and cost effective offline flyback
converter applications.
PWM switching frequency at normal operation is
internally fixed and is trimmed to tight range. At no
load or light load condition, the IC operates in
extended ‘burst mode’ to minimize switching loss.
Lower standby power and higher conversion
efficiency is thus achieved.
VCC low startup current and low operating current
contribute to a reliable power on startup and low
standby design with OB2283.
OB2283 offers comprehensive protection
coverage with auto-recovery including Cycle-by-
Cycle current limiting (OCP), over load protection
(OLP), and VCC under voltage lockout (UVLO). It
also provides the protections with latched shut
down including over temperature protection (OTP),
and over voltage protection (OVP). Excellent EMI
performance is achieved with On-Bright
proprietary frequency shuffling technique.
The tone energy at below 25KHz is minimized in
the design and audio noise is eliminated during
operation.
OB2283 is offered in SOT23-6 package.
APPLICATIONS
Offline AC/DC flyback converter for
■ Printer, Storage power supply
■ Power Adapter
FEATURES
■ Power on soft start reducing MOSFET Vds
stress
■ Frequency shuffling for EMI
■ Extended burst mode control for improved
efficiency and low standby power design
■ Audio noise free operation
■ Peak load operation with increased frequency
■ Comprehensive protection coverage
o VCC Under Voltage Lockout with
hysteresis (UVLO)
o VCC Over Voltage Protection (VCC OVP)
o Cycle-by-cycle over current threshold
setting for constant output power limiting
over universal input voltage range
o Over Load Protection (OLP) with auto-
recovery
o External (if NTC resistor is connected at
PRT pin)or internal Over Temperature
Protection (OTP) with latched shut down
o Output Over Voltage Protection(Output
OVP) with latched shut down, and the
OVP triggered voltage can be adjusted by
the resistor connected between auxiliary
winding and PRT pin
o Output diode short protection with auto-
recovery
o GND open protection with auto-recovery
TYPICAL APPLICATION
AC IN
EMI
Filter
OB2283
6 FB VCC 1
5 PRT
CS 2
4 GND GATE 3
Vaux
DC
Out
©On-Bright Electronics
Confidential
-1-
Preliminary Datasheet
OB_DOC_DS_228300
1 page  
OB2283
High Performance Current Mode PWM Controller
ELECTRICAL CHARACTERISTICS
(TA = 25℃, VCC=18V, unless otherwise noted)
Symbol
Parameter
Test Conditions
Min Typ Max
Supply Voltage (VDD)
Istartup
VCC Start up Current
VCC=UVLO(OFF)-1V,
measure
leakage
current into VCC
I_VCC_Operation Operation Current
VDD=18V,CS=4V,
FB=3.5V,measure
I(VCC)
I_VCC_Burst
Burst Current
CS=0V,FB=0.5V,
measure I(VCC)
UVLO(ON)
VCC Under Voltage Lockout
Enter
7
UVLO(OFF)
VCC Under Voltage Lockout
Exit (Recovery)
19
Vpull-up
Pull-up PMOS active
OVP
VCC Over Voltage
threshold voltage
Protection
FB=3V,CS=0V. Slowly
ramp VCC, until no
gate switching.
29
Vlatch_release
Latch release voltage
3 10
2.5 3
0.55 0.65
89
21 23
10
30 31
5
Feedback Input Section(FB Pin)
VFB_Open
VFB Open Loop Voltage
Avcs
PWM input gain ∆VFB/∆VCS
Maximum
cycle
duty Max duty cycle @
VCC=18V,VFB=3V,VCS=0V
75
Vref_green
The threshold enter green mode
Vref_burst_H
The threshold exits burst mode
Vref_burst_L
The threshold enters burst
mode
IFB_Short
FB pin short circuit current
Short FB pin to GND
and measure current
VTH_OLP
Open loop protection, FB
Threshold Voltage
Td_OLP
Open loop protection,
Debounce Time
ZFB_IN
Input Impedance
Current Sense Input(CS Pin)
SST_CS
Soft start time for CS peak
T_blanking
Leading edge blanking time
Td_OC
Over Current
Control Delay
Detection
From Over Current
and Occurs till the Gate
driver output start to
turn off
VTH_OC
Internal Current Limiting
Threshold Voltage with zero
duty cycle
0.43
VTH_OC_Clamp OCP CS voltage clamper
5.1
3.5
78
1.85
1.33
1.23
0.3
4.4
15
16
4
250
90
0.45
0.69
81
0.47
Vdiode_scp
Diode short protection voltage
1.4
Unit
uA
mA
mA
V
V
V
V
V
V
V/V
%
V
V
V
mA
V
ms
Kohm
ms
ns
ns
V
V
V
Td_dio
Diode short debounce time
8 Cycles
©On-Bright Electronics
Confidential
-5-
Preliminary Datasheet
OB_DOC_DS_228300
5 Page 
OB2283
High Performance Current Mode PWM Controller
IMPORTANT NOTICE
RIGHT TO MAKE CHANGES
On-Bright Electronics Corp. reserves the right to make corrections, modifications, enhancements,
improvements and other changes to its products and services at any time and to discontinue any product
or service without notice. Customers should obtain the latest relevant information before placing orders
and should verify that such information is current and complete.
WARRANTY INFORMATION
On-Bright Electronics Corp. warrants performance of its hardware products to the specifications
applicable at the time of sale in accordance with its standard warranty. Testing and other quality control
techniques are used to the extent it deems necessary to support this warranty. Except where mandated
by government requirements, testing of all parameters of each product is not necessarily performed.
On-Bright Electronics Corp. assumes no liability for application assistance or customer product design.
Customers are responsible for their products and applications using On-Bright’s components, data sheet
and application notes. To minimize the risks associated with customer products and applications,
customers should provide adequate design and operating safeguards.
LIFE SUPPORT
On-Bright Electronics Corp.’s products are not designed to be used as components in devices intended to
support or sustain human life. On-bright Electronics Corp. will not be held liable for any damages or
claims resulting from the use of its products in medical applications.
MILITARY
On-Bright Electronics Corp.’s products are not designed for use in military applications. On-Bright
Electronics Corp. will not be held liable for any damages or claims resulting from the use of its products in
military applications.
©On-Bright Electronics
Confidential
- 11 -
Preliminary Datasheet
OB_DOC_DS_228300
11 Page | ||
| Páginas | Total 11 Páginas | |
| PDF Descargar | [ Datasheet OB2283.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| OB2283 | High Performance Current Mode PWM Controller | On-Bright Electronics |
| OB2287 | High Performance Current Mode PWM Controller | On-Bright Electronics |
| OB2288 | Highly Integrated Current Mode PWM Controller | On-Bright Electronics |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |