|
|
Número de pieza | NL12880BC20-05D | |
Descripción | TFT COLOR LCD MODULE | |
Fabricantes | NEC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de NL12880BC20-05D (archivo pdf) en la parte inferior de esta página. Total 32 Páginas | ||
No Preview Available ! TFT COLOR LCD MODULE
NL12880BC20-05D
31cm (12.1 Type)
WXGA
LVDS interface (1port)
DATA SHEET
DOD-PP-1174 (2nd edition)
This DATA SHEET is updated document from
DOD-PP-1124(1).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-1174 (2nd edition)
Published date: February 2011 CP(N)
1 © NEC LCD Technologies, Ltd.
2010-2011 All rights reserved.
1 page NL12880BC20-05D
2. GENERAL SPECIFICATIONS
Display area
261.12 (H) × 163.2 (V) mm
Diagonal size of display 31cm (12.1 inches)
Drive system
a-Si TFT active matrix
Display color
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
Pixel
1280 (H) × 800 (V) pixels
Pixel arrangement
RGB (Red dot, Green dot, Blue dot) vertical stripe
Dot pitch
0.068 (H) × 0.204 (V) mm
Pixel pitch
0.204 (H) × 0.204 (V) mm
Module size
277.7 mm (W) (typ.) × 180.6 mm (H) (typ.) × 8.7 (D) mm (typ.)
Weight
460 g (typ.)
Contrast ratio
1,000:1 (typ.)
Viewing angle
At the contrast ratio ≥10:1
• Horizontal: Right side 88° (typ.), Left side 88° (typ.)
• Vertical: Up side 88° (typ.), Down side 88° (typ.)
At DPS= Low or Open: Normal scan
Designed viewing direction • Viewing angle with optimum grayscale (γ≒ 2.2): Normal axis
(perpendicular)
Polarizer surface
Antiglare
Polarizer pencil-hardness 3H (min.) [by JIS K5600]
Color gamut
At LCD panel center
40 % (typ.) [against NTSC color space]
Response time
Ton+Toff (10%←→ 90%)
25 ms (typ.)
Luminance
At IL= 50mA/One circuit
450 cd/m2 (typ.)
Signal system
LVDS 1port
(Receiver: THC63LVDF84B, THine Electronics Inc. or equivalent)
[8bit/6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
Power supply voltage
LCD panel signal processing board: 3.3V
LED backlight type:
Backlight
Power consumption
Replaceable part
• Lamp holder set: Type No. 121LHS30
Recommended LED driver board (Option)
• LED driver board: Type No. 104PW03F
• Corresponding wiring harness: Type No. 121CBL02
At IL= 50mA/One circuit, Checkered flag pattern
6.45W (typ.)
DATA SHEET DOD-PP-1174 (2nd edition)
5
5 Page 4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μs ≤ Tr < 50ms
Display signals*
Function signals
Note2
0V
0ms < t < 35ms
VALID period
NL12880BC20-05D
OFF ON
0.3V
Toff ≥ 50ms
0ms < t < 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: If there is a voltage variation (voltage drop) at the rising edge of VCC below 3.0V, there is a
possibility that a product does not work due to a protection circuit.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/- and CLK+/-) and function signals (DPS, FRC
and MSL) must be set to Low or High-impedance, except the VALID period (See above
sequence diagram), in order to avoid the circuitry damage.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If a customer stops the
display and function signals, VCC also must be shut down.
4.4.2 LED driver board
Display signals,
Function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-1174 (2nd edition)
11
11 Page |
Páginas | Total 32 Páginas | |
PDF Descargar | [ Datasheet NL12880BC20-05D.PDF ] |
Número de pieza | Descripción | Fabricantes |
NL12880BC20-05 | TFT COLOR LCD MODULE | NEC |
NL12880BC20-05D | TFT COLOR LCD MODULE | NEC |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |