DataSheet39.com

X1227 Datasheet PDF - Intersil Corporation

Part Number X1227
Description RTC Real TimeClock/Calendar/ CPU Supervisor
Manufacturers Intersil Corporation 
Logo Intersil Corporation Logo 

Preview ( 28 pages )
		
X1227 datasheet, circuit
® NOT RDENaSCtEaEOWESMDhIMSEeELeS1NtIG2D0NE2SD7 FOR
May 8, 2006
X1227
FN8099.2
2-WireRTC Real TimeClock/Calendar/
CPU Supervisor with EEPROM
FEATURES
• Real Time Clock/Calendar
— Tracks Time in Hours, Minutes, and Seconds
— Day of the Week, Day, Month, and Year
• 2 Polled Alarms (Non-volatile)
— Settable on the Second, Minute, Hour, Day of the
Week, Day, or Month
— Repeat Mode (periodic interrupts)
• Oscillator Compensation on Chip
— Internal Feedback Resistor and Compensation
Capacitors
— 64 Position Digitally Controlled Trim Capacitor
— 6 Digital Frequency Adjustment Settings to ±30ppm
• CPU Supervisor Functions
— Power-On Reset, Low Voltage Sense
— Watchdog Timer (SW Selectable: 0.25s, 0.75s,
1.75s, off)
• Battery Switch or Super Cap Input
• 512 x 8 Bits of EEPROM
— 64-Byte Page Write Mode
— 8 Modes of Block Lock™ Protection
— Single Byte Write Capability
• High Reliability
www.DataSheet4U.com — Data Retention: 100 Years
— Endurance: 100,000 Cycles Per Byte
• 2-Wire™ Interface Interoperable with I2C*
— 400kHz Data Transfer Rate
• Low Power CMOS
— 1.25µA Operating Current (Typical)
• Small Package Options
— 8 Ld SOIC and 8 Ld TSSOP
• Repetitive Alarms
• Temperature Compensation
• Pb-Free Plus Anneal Available (RoHS Compliant)
APPLICATIONS
• Utility Meters
• HVAC Equipment
• Audio/Video Components
• Set Top Box/Television
• Modems
• Network Routers, Hubs, Switches, Bridges
• Cellular Infrastructure Equipment
• Fixed Broadband Wireless Equipment
• Pagers/PDA
• POS Equipment
• Test Meters/Fixtures
• Office Automation (Copiers, Fax)
• Home Appliances
• Computer Products
• Other Industrial/Medical/Automotive
DESCRIPTION
The X1227 device is a Real Time Clock with
clock/calendar, two polled alarms with integrated 512x8
EEPROM, oscillator compensation, CPU Supervisor
(POR/LVS and WDT) and battery backup switch.
The oscillator uses an external, low-cost 32.768kHz
crystal. All compensation and trim components are
integrated on the chip. This eliminates several external
discrete components and a trim capacitor, saving
board area and component cost.
BLOCK DIAGRAM
OSC
Compensation
32.768kHz
X1
X2
Oscillator
Frequency 1Hz
Divider
Timer
Calendar
Logic
Time
Keeping
Registers
(SRAM)
Battery
Switch
Circuitry
VCC
VBACK
SCL
SDA
Serial
Interface
Decoder
RESET
Control
Decode
Logic
8
Control/
Registers
(EEPROM)
Status
Registers
(SRAM)
Alarm
Watchdog
Timer
Low Voltage
Reset
Compare
Alarm Regs
(EEPROM)
4K
EEPROM
ARRAY
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005-2006. All Rights Reserved
*I2C is a Trademark of Philips. All other trademarks mentioned are the property of their respective owners.

No Preview Available !


1 page
line_dark_gray
X1227 equivalent
X1227
(9) VSDA =VSCL=VBACK, Others = GND or VBACK
(10)VSDA = GND or VCC, VSCL = GND or VCC, VRESET = GND or VCC
(11)IOL = 3.0mA at 5.5V, 1.5mA at 2.7V
(12) IOH = -1.0mA at 5.5V, -0.4mA at 2.7V
(13)Threshold voltages based on the higher of Vcc or Vback.
(14)Using recommended crystal and oscillator network applied to X1 and X2 (25°C).
(15)Typical values are for TA = 25°C
Capacitance TA = 25°C, f = 1.0 MHz, VCC = 5V
Symbol
Parameter
Max.
Units
Test Conditions
COUT(1)
CIN(1)
Output Capacitance (SDA, RESET)
Input Capacitance (SCL)
10 pF
10 pF
VOUT = 0V
VIN = 0V
Notes: (1) This parameter is not 100% tested.
(2) The input capacitance between x1 and x2 pins can be varied between 5pF and 19.75pF by using analog trimming registers
AC CHARACTERISTICS
AC Test Conditions
Input Pulse Levels
Input Rise and Fall Times
Input and Output Timing
Levels
Output Load
VCC x 0.1 to VCC x 0.9
10ns
VCC x 0.5
Standard Output Load
Figure 1. Standard Output Load for testing the device with VCC = 5.0V
Equivalent AC Output Load Circuit for VCC = 5V
5.0V
SDA
1533Ω
For VOL= 0.4V
and IOL = 3 mA
100pF
5 FN8099.2
May 8, 2006

5 Page
line_dark_gray


Information Total 28 Pages
Download[ X1227.PDF Datasheet ]

Share Link :

Electronic Components Distributor

SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Element14 Chip One Stop



Featured Datasheets

Part NumberDescriptionManufacturers
X1226The function is Real Time Clock/Calendar with EEPROM.Xicor
Xicor
X1226The function is Real Time Clock/Calendar.Intersil Corporation
Intersil Corporation
X1227The function is Real Time Clock/Calendar/CPU Supervisor with EEPROM.Xicor
Xicor

Quick jump to:

X122  1N4  2N2  2SA  2SC  74H  ADC  BC  BF  BU  CXA  HCF  IRF  KA  KIA  LA  LM  MC  NE  ST  STK  TDA  TL  UA 


DataSheet39.com is an Online Datasheet PDF Search Site.
It offers a large amount of data sheet, You can free PDF files download.
The updated every day, always provide the best quality and speed.



keyword : X1227 schematic, X1227 equivalent, X1227 pinout

DataSheet39.com   |  2018   |  Privacy Policy |  Contact Us  | New  |  Search