DataSheet39.com

What is LM324?

This electronic component, produced by the manufacturer "STMicroelectronics", performs the same function as "LOW POWER QUAD OPERATIONAL AMPLIFIERS".


LM324 Datasheet PDF - STMicroelectronics

Part Number LM324
Description LOW POWER QUAD OPERATIONAL AMPLIFIERS
Manufacturers STMicroelectronics 
Logo STMicroelectronics Logo 


There is a preview and LM324 download ( pdf file ) link at the bottom of this page.





Total 21 Pages



Preview 1 page

No Preview Available ! LM324 datasheet, circuit

LM124, LM224x, LM324x
Low-power quad operational amplifiers
Datasheet - production data
Features
Wide gain bandwidth: 1.3 MHz
Input common mode voltage range includes
ground
Large voltage gain: 100 dB
Very low supply current/amplifier: 375 µA
Low input bias current: 20 nA
Low input voltage: 3 mV max
Low input offset current: 2 nA
Wide power supply range:
Single supply: 3 V to 30 V
Dual supplies: ±1.5 V to ±15 V
Related products
See TSB572 and TSB611, 36 V newer
technology devices, which have enhanced
accuracy and ESD rating, reduced power
consumption, and automotive grade
qualification
See LM2902 and LM2902W for automotive
grade applications
Description
These circuits consist of four independent, high
gain operational amplifiers with frequency
compensation implemented internally. They
operate from a single power supply over a wide
range of voltages.
Operation from split power supplies is also
possible and the low-power supply current drain
is independent of the magnitude of the power
supply voltage.
Table 1: Device summary
Product reference
Part numbers
LM124 (1)
LM224x
LM124
LM224, LM224A (2), LM224W (3)
LM324x
LM324, LM324A, LM324W
Notes:
(1)Prefixes LM1, LM2, and LM3 refer to temperature range.
(2)Suffix A refers to enhanced Vio performance
(3)Suffix W refers to enhanced ESD ratings
June 2016
DocID4797 Rev 7
This is information on a product in full production.
1/21
www.st.com

line_dark_gray
LM324 equivalent
LM124, LM224x, LM324x
Absolute maximum ratings and operating
conditions
2 Absolute maximum ratings and operating conditions
Symbol
Table 2: Absolute maximum ratings
Parameter
Value
Unit
VCC Supply voltage
Vi Input voltage
Vid Differential input voltage (1)
Ptot Power dissipation: D suffix
Output short-circuit duration (2)
Iin Input current (3)
Tstg Storage temperature range
Tj Maximum junction temperature
Rthja Thermal resistance junction to ambient (4)
Rthjc Thermal resistance junction to case
ESD
HBM: human body model (5)
MM: machine model (6)
CDM: charged device model
QFN16 3x3
TSSOP14
SO14
QFN16 3x3
TSSOP14
SO14
LM224A, LM324A
LM124W, LM324W
LM124, LM224, LM324
±16 or 32
-0.3 to VCC + 0.3
32
400
Infinite
50
-65 to 150
150
45
100
103
14
32
31
800
700
250
100
1500
V
mW
mA
°C
°C/W
V
Notes:
(1)Neither of the input voltages must exceed the magnitude of (VCC+) or (VCC-).
(2)Short-circuits from the output to VCC can cause excessive heating if VCC > 15 V. The maximum output current is approximately
40 mA independent of the magnitude of VCC. Destructive dissipation can result from simultaneous short-circuits on all amplifiers.
(3)This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base junction
of the input PNP transistor becoming forward biased and thereby acting as an input diode clamp. In addition to this diode action,
there is also an NPN parasitic action on the IC chip. This transistor action can cause the output voltages of the op amps to go to
the VCC voltage level (or to ground for a large overdrive) for the time during which an input is driven negative. This is not
destructive and normal output starts up again for input voltages higher than -0.3 V.
(4)Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-circuits on all amplifiers.
These are typical values given for a single layer board (except for TSSOP which is a two-layer board).
(5)Human body model: 100 pF discharged through a 1.5 kΩ resistor between two pins of the device, done for all couples of pin
combinations with other pins floating.
(6)Machine model: a 200 pF cap is charged to the specified voltage, then discharged directly between two pins of the device with
no external series resistor (internal resistor < 5 Ω), done for all couples of pin combinations with other pins floating.
DocID4797 Rev 7
5/21


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for LM324 electronic component.


Information Total 21 Pages
Link URL [ Copy URL to Clipboard ]
Product Image
and Detail view

LM324 PDF Datasheet


1. Quad OP Amplifier - Intersil

[ Learn More ]




Download [ LM324.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
LM32The function is 3-Terminal Negative Regulators. National SemiconductorNational Semiconductor
LM32The function is Low Power Single Op Amp. National SemiconductorNational Semiconductor
LM32The function is Dual Voltage Regulator. National SemiconductorNational Semiconductor

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

LM32     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search