DataSheet39.com

What is UT8Q1024K8?

This electronic component, produced by the manufacturer "Aeroflex Circuit Technology", performs the same function as "high-performance 1M byte (8Mbit) CMOS static RAM".


UT8Q1024K8 Datasheet PDF - Aeroflex Circuit Technology

Part Number UT8Q1024K8
Description high-performance 1M byte (8Mbit) CMOS static RAM
Manufacturers Aeroflex Circuit Technology 
Logo Aeroflex Circuit Technology Logo 


There is a preview and UT8Q1024K8 download ( pdf file ) link at the bottom of this page.





Total 15 Pages



Preview 1 page

No Preview Available ! UT8Q1024K8 datasheet, circuit

Standard Products
QCOTSTM UT8Q1024K8 SRAM
Data Sheet
January, 2003
FEATURES
‰ 25ns maximum (3.3 volt supply) address access time
‰ Dual cavity package contains two (2) 512K x 8 industry-
standard asynchronous SRAMs; the control architecture
allows operation as an 8-bit data width
‰ TTL compatible inputs and output levels, three-state
bidirectional data bus
‰ Typical radiation performance
- Total dose: 50krad(Si)
- SEL Immune >80 MeV-cm2/mg
- LETTH(0.25) = >10 MeV-cm2/mg
- Saturated Cross Section cm2 per bit, 5.0E-9
- <1E-8 errors/bit-day, Adams 90% geosynchronous
heavy ion
‰ Packaging options:
- 44-lead bottom brazed dual CFP (BBTFP) (4.6 grams)
‰ Standard Microcircuit Drawing 5962-01532
- QML T and Q compliant part
INTRODUCTION
The QCOTSTM UT8Q1024K8 Quantified Commercial Off-the-
Shelf product is a high-performance 1M byte (8Mbit) CMOS
static RAM built with two individual 524,288 x 8 bit SRAMs
with a common output enable. Memory access and control is
provided by an active LOW chip enable (En), an active LOW
output enable (G). This device has a power-down feature that
reduces power consumption by more than 90% when deselected.
Writing to each memory is accomplished by taking one of the
chip enable (En) inputs LOW and write enable (Wn) inputs
LOW. Data on the I/O pins is then written into the location
specified on the address pins (A0 through A18). Reading from
the device is accomplished by taking one of the chip enable (En)
and output enable (G) LOW while forcing write enable (Wn)
HIGH. Under these conditions, the contents of the memory
location specified by the address pins will appear on the I/O pins.
Only one SRAM can be read or written at a time.
The input/output pins are placed in a high impedance state when
the device is deselected (En HIGH), the outputs are disabled (G
HIGH), or during a write operation (En LOW and Wn LOW).
A(18:0)
G
E1 W1
E0 W0
512K x 8
512K x 8
DQ(7:0)
Figure 1. UT8Q1024K8 SRAM Block Diagram
1

line_dark_gray
UT8Q1024K8 equivalent
DC ELECTRICAL CHARACTERISTICS (Pre/Post-Radiation)*
(-40°C to +125°C) (VDD = 3.3V + 0.3)
SYMBOL
PARAMETER
CONDITION
MIN
VIH High-level input voltage
(CMOS)
2.0
VIL Low-level input voltage
(CMOS)
VOL1 Low-level output voltage
IOL = 8mA, VDD =3.0V
VOL2 Low-level output voltage
IOL = 200µA,VDD =3.0V
VOH1 High-level output voltage
IOH = -4mA,VDD =3.0V
2.4
VOH2 High-level output voltage
IOH = -200µA,VDD =3.0V
VDD-0.10
CIN1 Input capacitance
ƒ = 1MHz @ 0V
CIO1 Bidirectional I/O capacitance
ƒ = 1MHz @ 0V
IIN Input leakage current
VSS < VIN < VDD, VDD = VDD (max)
-2
IOZ Three-state output leakage current 0V < VO < VDD
VDD = VDD (max)
G = VDD (max)
-2
I
2,
OS
3
Short-circuit output current
0V < VO < VDD
-90
IDD(OP) Supply current operating
@ 1MHz
Inputs: VIL = 0.8V,
VIH = 2.0V
IOUT = 0mA
VDD = VDD (max)
IDD1(OP) Supply current operating
@40MHz
IDD2(SB) Nominal standby supply current
@0MHz
Inputs: VIL = 0.8V,
VIH = 2.0V
IOUT = 0mA
VDD = VDD (max)
Inputs: VIL = VSS
IOUT = 0mA
En = VDD - 0.5,
VDD = VDD (max)
VIH = VDD - 0.5V
-40°C and 25°C
+125°C
Notes:
* Post-radiation performance guaranteed at 25°C per MIL-STD-883 Method 101 9 .
1. Measured only for initial qualification and after process or design changes that could affect input/output capacitance.
2. Supplied as a design limit but not guaranteed or tested.
3. Not more than one output may be shorted at a time for maximum duration of one second.
MAX
0.8
0.4
0.08
20
24
2
2
90
150
220
4
25
UNIT
V
V
V
V
V
V
pF
pF
µA
µA
mA
mA
mA
mA
mA
5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for UT8Q1024K8 electronic component.


Information Total 15 Pages
Link URL [ Copy URL to Clipboard ]
Download [ UT8Q1024K8.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
UT8Q1024K8The function is high-performance 1M byte (8Mbit) CMOS static RAM. Aeroflex Circuit TechnologyAeroflex Circuit Technology
UT8Q1024K8-UPAThe function is high-performance 1M byte (8Mbit) CMOS static RAM. Aeroflex Circuit TechnologyAeroflex Circuit Technology
UT8Q1024K8-UPCThe function is high-performance 1M byte (8Mbit) CMOS static RAM. Aeroflex Circuit TechnologyAeroflex Circuit Technology

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

UT8Q     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search