DataSheet39.com

What is UPD9903GT?

This electronic component, produced by the manufacturer "NEC", performs the same function as "UPD9903 ANALOG SUBSCRIBER LINE LSI DIGITAL CODEC".


UPD9903GT Datasheet PDF - NEC

Part Number UPD9903GT
Description UPD9903 ANALOG SUBSCRIBER LINE LSI DIGITAL CODEC
Manufacturers NEC 
Logo NEC Logo 


There is a preview and UPD9903GT download ( pdf file ) link at the bottom of this page.





Total 28 Pages



Preview 1 page

No Preview Available ! UPD9903GT datasheet, circuit

DATA SHEET
MOS INTEGRATED CIRCUIT
µPD9903
µPD9903 ANALOG SUBSCRIBER LINE LSI (DIGITAL CODEC)
The µPD9903 is a digital CODEC that can be used in analog subscriber circuits such as private branch exchangers
(PBXs) and switching equipment for central offices. It features three of the functions required for analog subscriber
circuits: 2W/4W conversion, CODEC supervision, and subscriber line supervision.
Use of the µPD9903 in combination with a BS-SLIC (µPC7073) can reduce the number of components required
in analog subscriber circuits.
FEATURES
Single-chip monolithic LSI (CMOS)
PCM CODEC oversampling-type A/D and D/A converters
Programmable functions
• Termination impedance
• Hybrid balance network
• Feed resistance
• Feed current
• PAD control
• A-law and µ-law
• Digital gain set function
• Ring-Trip function
• Single power supply (+5 V)
• Low power consumption during standby mode: 20 mW (TYP.)
ORDERING INFORMATION
Part Number
µPD9903GT
Package
48-pin plastic shrink SOP (375 mil)
The information in this document is subject to change without notice.
Document No. S10897EJ3V0DS00 (3rd edition)
Date Published June 1997 N
Printed in Japan
The mark shows major revised points.
©
1996

line_dark_gray
UPD9903GT equivalent
µPD9903
1. PIN FUNCTIONS
Number
1-10
11
12
13
14
15
16
17
Pin Name
NC
AVDD
DVDD1
DVDD2
AUX/MODE
BSY
SUS
RST
18 EXS
19 EXD
20 HWR
21 DCLK
22 FS
23 HWX
24 TYPE
25 RTIN1
26 RTIN0
27 RC3
28 RC2
29 RC1
30 BCUT
31 ALM
32 PD
33 DGND2
34 DGND1
35 SUB
36 AGND
37 ACOMIN
38 ACOMOUT
39 AOUT
40 AIN
41 AGDT
42 ASCN
43 BBIN
I/O Function
– Leave this pin open.
– +5 V power supply (analog)
– +5 V power supply (digital)
– +5 V power supply (digital)
I External signaling input
O BUSY LED driver output
O SUS LED driver output
I Pin for reset input and power-on reset
H: HWX valid, L: HWX output’s internal F/F clear status
O SIPO sync signal output for expansion port Note 1
O SIPO serial data output for expansion port Note 1
I Reception highway input [PCM data (8-bit) + CTL data (8-bit)]
I Clock input (2.048 MHz)
I 8-kHz sync input Rising : HWR PCM data input start
Rising : HWX PCM data output start
Falling: HWR CTL data input start
Falling: HWX SCN data output start
O Transmission highway output [PCM data (8-bit) + SCN data (8-bit)]
O HWX data enable
I Ring-Trip signal input 2
I Ring-Trip signal input 1
O Relay control for network testing
O Relay control for line testing
O Relay control for ringer transmit
O High and wet control output
[to the µPC7073’s pin 22]
[to the µPC7073’s pin 21]
[to the µPC7073’s pin 20]
[to the µPC7073’s pin 19]
O Control output for ground-fault/power line contact protection mode
[to the µPC7073’s pin 18]
O Power-down control output
[to the µPC7073’s pin 17]
– Digital ground 2 Note 2
– Digital ground 1 Note 2
– Substrate ground Note 2
– Analog ground Note 2
I Signal ground input Note 3
O Signal ground output Note 3
O Analog signal output for receive side
[to the µPC7073’s pin 11]
[to the µPC7073’s pin 11]
[to the µPC7073’s pin 10]
I Analog signal input for transmit side
I Tip-Ring sum current detection input
I Tip-Ring difference current detection input
[to the µPC7073’s pin 9]
[to the µPC7073’s pin 8]
[to the µPC7073’s pin 7]
I VBB voltage information input
[to the µPC7073’s pin 6]
Notes 1. SIPO: Serial In Parallel Out
2. Short AGND, DGND1, DGND2, and SUB directly under the IC and connect them to an analog ground.
3. Short ACOMIN and ACOMOUT directly under the IC.
5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for UPD9903GT electronic component.


Information Total 28 Pages
Link URL [ Copy URL to Clipboard ]
Download [ UPD9903GT.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
UPD9903GTThe function is UPD9903 ANALOG SUBSCRIBER LINE LSI DIGITAL CODEC. NECNEC

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

UPD9     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search