DataSheet39.com

What is 73M2910L?

This electronic component, produced by the manufacturer "ETC", performs the same function as "Microcontroller".


73M2910L Datasheet PDF - ETC

Part Number 73M2910L
Description Microcontroller
Manufacturers ETC 
Logo ETC Logo 


There is a preview and 73M2910L download ( pdf file ) link at the bottom of this page.





Total 30 Pages



Preview 1 page

No Preview Available ! 73M2910L datasheet, circuit

DESCRIPTION
The 73M2910L high performance micro-controller is
based on the industry standard 8-bit 8032
implemented in an advanced submicron CMOS
process. The processor has the attributes of the
8032, including instruction cycle time, UART, timers,
interrupts, 256 bytes of on-chip RAM and
programmable I/O. The architecture has been
optimized for low power portable modem or
communication applications by integrating unique
features with the core CPU.
A key feature is a user friendly HDLC Packetizer,
accessed through the special function registers. It
has a serial I/O, hardware support for 16 and 32-bit
CRC, zero insert/delete control, a dedicated interrupt
and a clear channel mode for by-passing the
packetizer.
Other features include additional user programmable
I/O with programmable bank select and chip select
logic, designed to eliminate board level glue logic. It
also includes two general-purpose input ports with
programmable wakeup capability.
For devices that require non-multiplexed address
and data buses, eight latched outputs for the low
byte of the address are available.
(continued)
BLOCK DIAGRAM
73M2910L
Microcontroller
April 2000
FEATURES
8032 compatible instruction set
44 MHz Operation from 3.3 to 5.5V
HDLC support logic (Packetizer, 16 and 32
CRC, zero ID)
24 pins for user programmable I/O ports
8 pins programmable chip select logic or I/O
for memory mapped peripheral eliminating
glue logic
3 external interrupt sources (programmable
polarity)
16 dedicated latched address pins
Multiplexed data/address bus
Instruction cycle time identical to 8032
Buffered oscillator (or OSC/2) output pin
1.8432 MHz UART clock available
Bank select circuitry to support up to 128k of
external program memory
Also available in 100-Lead QFP and 100-Pin
PGA packages
(2:0)
INTERRUPT
CONTROL
USR 1.0
USR 1.1
USR 1.2
USR 1.3
TIMERS
RXD
TXD
PTXCLK
PTXD
PRXCLK
PRXD
UART
HDLC
TIME GEN
CPU
SFR BUS
RAM 256 X 8
ALE
MEM I/O CTRL
A (15:0)
D (7:0)
USR I/O
USR5 (1:0)
CSB (7:0)
USR3 (7:0)
USR I/O
USR2 (7:0)
USR1 (7:0)

line_dark_gray
73M2910L equivalent
73M2910L
Microcontroller
BIT 4 Clock 2 Output Enable
Bit 4 enables the clock at the CLOCK 2 output pin if it is set to a 1. The CLOCK 2 pin output is held to a 0, by
writing this bit to a 0. This will reduce system power if the clock pin is not used or if a power reduction mode is
required.
BITS 3,2 Clock 2 Output Control
These bits determine the oscillator divisor for the CLOCK 2 output pin. They were designed to provide a
1.8432 MHz clock for an external UART given an oscillator frequency of 11.0592 MHz, 22.1184 MHz,
18.432 MHz, or 13.824 MHz.
BIT 3
0
0
1
1
BIT 2
0
1
0
1
CLK 2 OUT
OSC/7.5
OSC/6
OSC/12
OSC/10
OSC FREQUENCY
13.824 MHz
11.059 MHz
22.118 MHz
18.432 MHz
BIT 1 Clock 1 Output Enable
Bit 1 enables the clock at the clock 1 output pin if it is set to a 1. The clock pin output is held to a 0, by writing a
0 to this bit. This will reduce system power if the clock pin is not used or if a power reduction mode is required.
Bit 6 is cleared to a 0 upon a reset.
BIT 0 Clock 1 Output Control
Bit 0 controls the frequency of the clock 1 output pin. The clock output is either the oscillator’s output signal
divided by two or a buffered oscillator output signal.
POWER SAVING MODES
Low Power Modes
The 73M2910L supports two power conservation modes, which are controlled by the PCON.1 and PCON.0
control bits of the PCON Register.
If PCON.0 is set, the 73M2910L will go into a power saving mode where the oscillator is running, clocks are
supplied to the UART, timers, HDLC, and interrupt blocks, but no clocks are supplied to the CPU. Instruction
processing and activity on the address and data ports is halted. Normal operation is resumed when an
unmasked interrupt is requested or when a reset occurs.
If PCON.1 is set, the 73M2910L goes into its lowest power mode where the oscillator is halted. The total current
consumption in this state should be less than 10 µa. The 73M2910L will start its oscillator and begin to return to
normal operation when either a reset occurs, when a falling (rising if corresponding direction bit is set) edge of
an unmasked external interrupt from pins INT(2:0) is detected, or when the USR5 (1:0) pins change to a state
according to the USR5 port register. Edges used in wakeup modes are not filtered in the
73M2910L, so the user must be cautious of noise or small glitches inadvertently waking up the chip. From the
time the edge that results in the wake up occurs, to the point at which an instruction is executed, depends on
the oscillator start-up time. Three good oscillator pulses must be detected before the main internal clocks are
generated.
During power-down mode, both the ALE and PSEN pins are pulled high since these signals often provide the
output enable and chip enable for the ROM (active low). This ensures that the external components are in their
lowest power state.
5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for 73M2910L electronic component.


Information Total 30 Pages
Link URL [ Copy URL to Clipboard ]
Download [ 73M2910L.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
73M2910LThe function is Microcontroller. ETCETC

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

73M2     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search