|
|
PDF TSOP58130 Data sheet ( Hoja de datos )
| Número de pieza | TSOP58130 | |
| Descripción | IR Receiver Modules | |
| Fabricantes | Vishay | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TSOP58130 (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
|
No Preview Available !
www.vishay.com
TSOP581.., TSOP583.., TSOP585..
Vishay Semiconductors
IR Receiver Modules for Remote Control Systems
19026
MECHANICAL DATA
Pinning for TSOP581.., TSOP583.., TSOP585:
1 = OUT, 2 = GND, 3 = VS
FEATURES
• Improved immunity against HF and RF noise
• Low supply current
• Photo detector and preamplifier in one package
• Internal filter for PCM frequency
• Improved shielding against EMI
• Supply voltage: 2.5 V to 5.5 V
• Suitable for short bursts: burst length ≥ 6 carrier
cycles
• Improved immunity against ambient light
• Insensitive to supply voltage ripple and noise
• Material categorization: for definitions of compliance
please see www.vishay.com/doc?99912
DESCRIPTION
These products are miniaturized receivers for infrared
remote control systems. A PIN diode and a preamplifier are
assembled on a lead frame, the epoxy package contains an
IR filter. The demodulated output signal can be directly
connected to a microprocessor for decoding.
The TSOP583.. series devices are optimized to suppress
almost all spurious pulses from Wi-Fi and CFL sources.
They may suppress some data signals if continuously
transmitted.
The TSOP581.. series devices are provided primarily for
compatibility with old AGC1 designs. New designs should
prefer the TSOP583.. series containing the newer AGC3.
The TSOP585.. series are useful to suppress even extreme
levels of optical noise, but may also suppress some data
signals. Please check compatibility with your codes.
These components have not been qualified according to
automotive specifications.
PARTS TABLE
AGC
30 kHz
33 kHz
Carrier
36 kHz
frequency 38 kHz
40 kHz
56 kHz
Package
Pinning
Dimensions (mm)
Mounting
Application
Best remote control code
LEGACY PRODUCT FOR
SHORT BURST REMOTE
CONTROLS (AGC1)
NOISY ENVIRONMENTS AND
SHORT BURSTS (AGC3)
VERY NOISY ENVIRONMENTS
AND SHORT BURSTS (AGC5)
TSOP58130
TSOP58330
TSOP58530
TSOP58133
TSOP58333
TSOP58533
TSOP58136
TSOP58336 (1)
TSOP58536
TSOP58138
TSOP58338 (2)(3)(4)(5)
TSOP58538
TSOP58140
TSOP58340
TSOP58540
TSOP58156
TSOP58356
TSOP58556
Minicast
1 = OUT, 2 = GND, 3 = VS
5.0 W x 6.95 H x 4.8 D
Leaded
Remote control
(1) MCIR (2) Mitsubishi (3) RECS-80 Code (4) r-map (5) XMP-1, XMP-2
Rev. 1.4, 22-Jul-16
1 Document Number: 82462
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
1 page  
www.vishay.com
TSOP581.., TSOP583.., TSOP585..
Vishay Semiconductors
SUITABLE DATA FORMAT
These products are designed to suppress spurious output
pulses due to noise or disturbance signals. Data and
disturbance signals can be distinguished by the devices
according to carrier frequency, burst length and envelope
duty cycle. The data signal should be close to the
band-pass center frequency (e.g. 38 kHz) and fulfill the
conditions in the table below.
When a data signal is applied to the IR receiver in the
presence of a disturbance signal, the sensitivity of the
receiver is reduced to insure that no spurious pulses are
present at the output. Some examples of disturbance
signals which are suppressed are:
• DC light (e.g. from tungsten bulb or sunlight)
• Continuous signals at any frequency
• Modulated IR signals from common fluorescent lamps
(example of noise pattern is shown in Fig. 15 or Fig. 16)
• 2.4 GHz and 5 GHz Wi-Fi
0
16920
5 10 15
Time (ms)
20
Fig. 15 - IR Disturbance from Fluorescent Lamp
with Low Modulation
0
16921
5 10 15
Time (ms)
20
Fig. 16 - IR Disturbance from Fluorescent Lamp
with High Modulation
Minimum burst length
After each burst of length
A gap time is required of
For bursts greater than
a minimum gap time in the data
stream is needed of
Maximum number of continuous
short bursts/second
MCIR code
XMP-1, XMP-2 code
Suppression of interference from
fluorescent lamps
TSOP581..
6 cycles/burst
6 to 70 cycles
≥ 10 cycles
70 cycles
> 1.2 x burst length
2000
Yes
Yes
Mild disturbance patterns
are suppressed (example:
signal pattern of Fig. 15)
TSOP583..
6 cycles/burst
6 to 35 cycles
≥ 10 cycles
35 cycles
> 6 x burst length
2000
Preferred
Preferred
Complex disturbance patterns
are suppressed (example:
signal pattern of Fig. 16)
TSOP585..
6 cycles/burst
6 to 24 cycles
≥ 10 cycles
24 cycles
> 25 ms
2000
Yes
Yes
Critical disturbance
patterns are suppressed,
e.g. highly dimmed LCDs
Note
• For data formats with long bursts (more than 10 carrier cycles) please see the datasheet for TSOP582.., TSOP584..
Rev. 1.4, 22-Jul-16
5 Document Number: 82462
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
5 Page | ||
| Páginas | Total 7 Páginas | |
| PDF Descargar | [ Datasheet TSOP58130.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TSOP58130 | IR Receiver Modules | Vishay |
| TSOP58133 | IR Receiver Modules | Vishay |
| TSOP58136 | IR Receiver Modules | Vishay |
| TSOP58138 | IR Receiver Modules | Vishay |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |