MB9BF104N Datasheet PDF - Fujitsu
Part Number | MB9BF104N | |
Description | 32-bit Microcontroller | |
Manufacturers | Fujitsu | |
Logo | ||
There is a preview and MB9BF104N download ( pdf file ) link at the bottom of this page. Total 30 Pages |
Preview 1 page No Preview Available ! FUJITSU SEMICONDUCTOR
DATA SHEET
DS706-00007-1v0-E
32-bit ARMTM CortexTM-M3 based Microcontroller
FM3 MB9B100 Series
MB9BF104N/R, F105N/R, F106N/R
DESCRIPTION
The MB9B100 Series are a highly integrated 32-bit microcontroller that target for high-performance and
cost-sensitive embedded control applications.
The MB9B100 Series are based on the ARM Cortex-M3 Processor and on-chip Flash memory and SRAM,
and peripheral functions, including Motor Control Timers, ADCs and Communication Interfaces (UART,
SIO, I2C, LIN).
Note: ARM and Cortex-M3 are the trademarks of ARM Limited in the EU and other countries.
Copyright2010-2011 FUJITSU SEMICONDUCTOR LIMITED All rights reserved
2011.1
|
|
MB9B100 Series
CRC (Cyclic Redundancy Check) Accelerator
The CRC accelerator helps a verify data transmission or storage integrity.
CCITT CRC16 and IEEE-802.3 CRC32 are supported.
・ CCITT CRC16 Generator Polynomial: 0x1021
・ IEEE-802.3 CRC32 Generator Polynomial: 0x04C11DB7
Clock and Reset
[Clocks]
Five clock sources (2 ext. osc, 2 CR osc, and PLL) that are dynamically selectable.
・ Main Clock
: 4 to 48MHz
・ Sub Clock
: 32.768kHz
・ High-speed CR Clock : 4MHz
・ Low-speed CR Clock : 100kHz
・ PLL Clock
[Resets]
Reset requests from INITX pins, Power on reset, Software reset, watchdog timers reset, low voltage
detector reset and clock supervisor reset.
Clock Super Visor (CSV)
Clocks generated by CR oscillators are used to supervise abnormality of the external clocks.
・ External OSC clock failure (clock stop) is detected, reset is asserted.
・ External OSC frequency anomaly is detected, interrupt or reset is asserted.
Low Voltage Detector (LVD)
MB9B100 Series include 2-stage monitoring of voltage on the VCC. When the voltage falls below the
voltage has been set, Low Voltage Detector generates an interrupt or reset.
・ LVD1: error reporting via interrupt
・ LVD2: auto-reset operation
Low Power Mode
Three power saving modes supported.
・ SLEEP
・ TIMER
・ STOP
Debug
・ Serial Wire JTAG Debug Port (SWJ-DP)
・ Embedded Trace Macrocells (ETM) provide comprehensive debug and trace facilities.
・ Trace Port Interface Unit (TPIU) for bridging to a Trace Port Analyzer.
Power Supply
Two Power Supplies
・ VCC = 2.7V to 5.5V: Correspond to the wide range voltage.
DS706-00007-1v0-E
5
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for MB9BF104N electronic component. |
Information | Total 30 Pages | |
Link URL | [ Copy URL to Clipboard ] | |
Download | [ MB9BF104N.PDF Datasheet ] |
Share Link :
Electronic Components Distributor
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
Part Number | Description | MFRS |
MB9BF104N | The function is 32-bit Microcontroller. Fujitsu | |
MB9BF104NA | The function is Microcontroller. Spansion | |
MB9BF104NA | The function is 32-bit ARM Cortex-M3 based Microcontroller. Fujitsu | |
Semiconductors commonly used in industry:
1N4148 |  
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
MB9B
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA |