DataSheet39.com

What is EL5237?

This electronic component, produced by the manufacturer "Intersil", performs the same function as "Dual Ultra Low Noise Wideband Amplifiers".


EL5237 Datasheet PDF - Intersil

Part Number EL5237
Description Dual Ultra Low Noise Wideband Amplifiers
Manufacturers Intersil 
Logo Intersil Logo 


There is a preview and EL5237 download ( pdf file ) link at the bottom of this page.





Total 19 Pages



Preview 1 page

No Preview Available ! EL5237 datasheet, circuit

Dual Ultra Low Noise Wideband AmplifiersNOc1NTo-8nOR8taE8Rc-CEItNOCoTMOuErMMRTMESeNIcELhDNonEDriDcEwaDFlwOSRwRuE.ipPnNpLtEeoArWrsCt iCElD.ceMEonSEmtIeNG/rTtNsacSt
EL5236, EL5237
Features
The EL5236 is a dual, low noise, 300MHz Gain Bandwidth
product Voltage Feedback Op Amp (VFA). The minimum operating
gain of 2 comes with a very low input noise voltage of 1.5nV/Hz
and 1.8pA/Hz current noise. This makes this dual device ideal
for low noise differential active filters, dual channel photodiode
detectors, differential receivers with equalization, and any other
wideband, high dynamic range application.
Each channel requires only 5.8mA on a ±6V supply. Minimal
performance change over a supply range of ±2.5V to ±6V is
provided (or single +5V ->+12V). Where system power is
paramount, the EL5237 dual with disable allows the amplifiers
to be separately powered down to less than 20µA/Ch.
The 8 Ld dual EL5236 is available in the industry standard
pinout SO-8 or space saving MSOP-8. The 10 Ld EL5237 is
available in an MSOP-10.
• Bandwidth (-3dB) of 250MHz @ AV = +2
• Gain Bandwidth Product: 300MHz
• Voltage Noise: 1.5nV/Hz
• Current Noise: 1.8pA/Hz
• IS: 5.8mA/Channel
• 100mA IOUT
• Fast Enable/Disable (EL5237 only)
±2.5V to ±6V Supply Range Operation
Applications
• Differential ADC Driver
• Complementary DAC Output Driver
• Ultrasound Input Amplifiers
• AGC and PLL Active Filters
• Transimpedance Designs
Related Products
ISL28290, Dual, 80MHz, 1nV/Hz
ISL55290, Dual, 700MHz, 1.1nV/Hz
422
+3.3V
ISL5861IB
LOW
POWER
12-BIT
DAC
130MSPS
0 TO 20mA
20mA TO 0
25
25
77
1.27nF
77
1.27nF
255
130pF
200
255
130pF
270pF
+5V
+
-
½ ISL5236
100
215
180pF
100
½- ISL5236
+
-5V
180pF
215
270pF
39pF 30pF
422
337
+5V
-
+ ½ ISL5236
4.66k
+5V
0.1µF
422
+ ½ ISL5236
-
-5V
39pF 30pF
422
0V CENTERED
4VP-P
DIFFERENTIAL
LOW POWER, LOW NOISE, DIFFERENTIAL DAC OUTPUT TRANSIMPEDANCE WITH A 5TH ORDER, 5MHz, BUTTERWORTH FILTER
FIGURE 1. TYPICAL APPLICATION
March 31, 2011
FN7833.0
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Copyright Intersil Americas Inc. 2011. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.

line_dark_gray
EL5237 equivalent
EL5236, EL5237
Electrical Specifications VS+ = +6V, VS- = -6V, RL = 500Ω, RF = RG = 620Ω, VCM = 0V, and TA = +25°C, Unless Otherwise
Specified. (Continued)
PARAMETER
SYMBOL
CONDITIONS
MIN MAX
(Note 6) TYP (Note 6) UNIT
OUTPUT CHARACTERISTICS
Output Swing High
Output Swing Low
Short Circuit Current
POWER SUPPLY PERFORMANCE
VOH RL = 500Ω
RL = 150Ω
VOL RL = 500Ω
RL = 150Ω
ISC RL = 10Ω (Sourcing and Sinking)
4.8 4.9
V
4.5 4.7
V
-4.8 -4.7
V
-4.6 -4.5
V
110 160
mA
Power Supply Rejection Ratio
Supply Current Enable (Per Amplifier)
Supply Current Disable (Per Amplifier) (EL5237)
Operating Range
ENABLE (EL5237)
PSRR VS is moved from ±5.4V to ±6.6V
IS ON No load
IS OFF +VS
-VS
VS Single Supply
75 85
dB
5.8 7 mA
2 20 µA
-26 -16
µA
5 12 V
Enable Time
Disable Time
EN Pin Input High Current
EN Pin Input Low Current
EN Pin Input High Voltage for Power-down
EN Pin Input Low Voltage for Power-up
tEN
tDIS
IIHEN
IILEN
VIHEN
VIHEN
EN = VS+
EN = VS-
125
336
17 20
-1 0.1
VS+ -1
VS- +3
ns
ns
µA
µA
V
V
Electrical Specifications
Specified.
PARAMETER
DYNAMIC PERFORMANCE
Gain Bandwidth Product
Slew Rate
Settling to 0.1% (AV = +2)
-3dB Bandwidth
-3dB Bandwidth
2nd Harmonic Distortion
3rd Harmonic Distortion
Voltage Noise
Current Noise
INPUT CHARACTERISTICS
Input Offset Voltage
Average Offset Voltage Drift
Input Bias Current
Input Offset Current
VS+ = +2.5V, VS- = -2.5V, RL = 500Ω, RF = RG = 620Ω, VCM = 0V, and TA = +25°C, Unless Otherwise
SYMBOL
CONDITIONS
MIN MAX
(Note 6) TYP (Note 6) UNIT
GBWP
SR
tS
BW1
BW2
HD2
HD3
en
in
VO = ±1.25V square wave, measured 25% to 75%
AV = +2, VO = ±1V
AV = -1
AV = +2
f = 1MHz, VO = 2VP-P, RL = 500
f = 1MHz, VO = 2VP-P, RL = 500
f = 100kHz
f = 100kHz
300
80 110
25
175
250
-94
-100
1.5
1.7
MHz
V/µs
ns
MHz
MHz
dBc
dBc
nV/Hz
pA/Hz
VOS VCM = 0V
TCVOS
IB VCM = 0V
IOS
-3 -0.2 +3 mV
-0.3 µV/°C
6.5 9 µA
-500 50 500 nA
5 FN7833.0
March 31, 2011


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for EL5237 electronic component.


Information Total 19 Pages
Link URL [ Copy URL to Clipboard ]
Download [ EL5237.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
EL5234The function is (EL5134 - EL5235) Low Noise Amplifiers. Intersil CorporationIntersil Corporation
EL5235The function is (EL5134 - EL5235) Low Noise Amplifiers. Intersil CorporationIntersil Corporation
EL5236The function is Dual Ultra Low Noise Wideband Amplifiers. IntersilIntersil

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

EL52     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search