DataSheet39.com

What is UDK2559?

This electronic component, produced by the manufacturer "Allegro MicroSystems", performs the same function as "PROTECTED QUAD POWER DRIVER".


UDK2559 Datasheet PDF - Allegro MicroSystems

Part Number UDK2559
Description PROTECTED QUAD POWER DRIVER
Manufacturers Allegro MicroSystems 
Logo Allegro MicroSystems Logo 


There is a preview and UDK2559 download ( pdf file ) link at the bottom of this page.





Total 8 Pages



Preview 1 page

No Preview Available ! UDK2559 datasheet, circuit

2559
Protected Quad Power Driver
Features and Benefits
700 mA output current per channel
Independent overcurrent protection for each driver
Thermal protection for device and each driver
Low output-saturation voltage
Integral output flyback diodes
TTL and 5 V CMOS-compatible inputs
Packages:
16-pin DIP
with exposed thermal tabs
(B package)
28-pin PLCC
(Package EB)
Not to scale
16-pin SOICW
with internally fused pins
(LB package)
Description
Providing improved output current limiting, the UDK,
UDN, and UDQ2559B, EB, and LB quad power drivers
combine AND logic gates and high-current bipolar outputs
with complete output protection. Each of the four outputs
sink 700 mA in the on state. The outputs have a minimum
breakdown voltage (load dump) of 60 V and a sustaining
voltage of 40 V. The inputs are compatible with TTL and
5 V CMOS logic systems.
Overcurrent protection for each channel has been designed
into these devices and is activated at approximately 1 A. It
protects each output from short circuits with supply voltages
up to 25 V. When an output current trip point is reached, that
output stage is driven linearly resulting in a reduced output
current level. If an over-current or short-circuit condition
continues, the thermal-limiting circuits will first sense the rise
in junction temperature and then the rise in chip temperature,
further decreasing the output current. Under worst-case
conditions, these devices will tolerate short circuits on all
outputs, simultaneously.
These devices can be used to drive various loads including
incandescent lamps (without warming or limiting resistors)
or inductive loads such as relays, solenoids, or dc stepping
motors.
The packages offer fused leads for enhanced thermal dissipation.
Package B is a 16-pin power DIP with exposed tabs, EB is a
28-lead power PLCC, and LB is a 16-lead power wide-body
SOIC for surface-mount applications. They are lead (Pb) free
with 100% matte tin leadframe plating.
ENABLE
INN
Functional Block Diagram
(1 of 4 Channels)
VCC
K
OUTN
Thermal
Limit
<< 1Ω
29317.14L

line_dark_gray
UDK2559 equivalent
2559
Protected Quad Power Driver
ELECTRICAL CHARACTERISTICS at TA = +25°C (prex ‘UDN’) or over operating
temperature range (prex ‘UDK’ or ‘UDQ’), VCC = 4.75 V to 5.25 V
Characteristic
Output Leakage Current
Output Sustaining Voltage
Output Saturation Voltage
Over-Current Trip
Input Voltage
Input Current
Total Supply Current*
Clamp Diode Forward Voltage
Clamp Diode Leakage Current
Turn-On Delay
Thermal Limit
Symbol
ICEX
VOUT(SUS)
VOUT(SAT)
ITRIP
Logic 1
Logic 0
Logic 1
Logic 0
ICC
VF
IR
tPHL
tPLH
TJ
Test Conditions
VOUT = 50 V, VIN = 0.8 V, VEN = 2.0 V
VOUT = 50 V, VIN = 2.0 V, VEN = 0.8 V
IOUT = 100 mA, VIN = VEN = 0.8 V
All Devices, IOUT = 100 mA
All Devices, IOUT = 400 mA
B or EB package only, IOUT = 600 mA
VIN(1) or VEN(1)
VIN(0) or VEN(0)
VIN(1) or VEN(1) = 2.0 V
VIN(0) or VEN(0) = 0.8 V
All Outputs ON, VIN = VEN = 2.0 V
All Outputs OFF
IF = 1.0 A
IF = 1.5 A
VR = 50 V, D1 + D2 or D3 + D4
IOUT = 500 mA
IOUT = 500 mA
Min.
40
2.0
Limits
Typ. Max.
<1.0 100
<1.0 100
——
— 300
— 500
— 700
1.0 —
——
— 0.8
— 40
— -10
— 80
— 5.0
— 1.7
— 2.1
— 50
— 20
— 20
165 —
Typical Data is for design information only.
Negative current is dened as coming out of (sourcing) the specied terminal.
As used here, -100 is dened as greater than +10 (absolute magnitude convention) and the minimum is implicitly zero.
* All inputs simultaneously, all other tests are performed with each input tested separately.
Units
μA
μA
V
mV
mV
mV
A
V
V
μA
μA
mA
mA
V
V
μA
μs
μs
°C
Allegro MicroSystems, Inc.
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for UDK2559 electronic component.


Information Total 8 Pages
Link URL [ Copy URL to Clipboard ]
Download [ UDK2559.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
UDK2559The function is PROTECTED QUAD POWER DRIVER. Allegro MicroSystemsAllegro MicroSystems

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

UDK2     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search