UDN2987LWTR-6-T Datasheet PDF - Allegro Microsystems
Part Number | UDN2987LWTR-6-T | |
Description | DABIC-5 8-Channel Source Driver | |
Manufacturers | Allegro Microsystems | |
Logo | ||
There is a preview and UDN2987LWTR-6-T download ( pdf file ) link at the bottom of this page. Total 9 Pages |
Preview 1 page No Preview Available ! UDN2987x-6
DABIC-5 8-Channel Source Driver
with Overcurrent Protection
Features and Benefits
▪ 4.75 to 35 V driver supply voltage
▪ Output enable-disable (OE/R)
▪ 350 mA output source current
▪ Overcurrent protected
▪ Internal ground clamp diodes
▪ Output Breakdown Voltage 35 V minimum
▪ TTL, DTL, PMOS, or CMOS compatible inputs
▪ Internal Thermal Shutdown (TSD)
Package: 20-pin SOICW (suffix LW)
Not to scale
Description
Providing overcurrent protection for each of its eight
sourcing outputs, the UDN2987LW-6 driver is used as an
interface between standard low-level logic and relays, motors,
solenoids, LEDs, and incandescent lamps. This device includes
thermal shutdown and output transient protection/clamp diodes
for use with sustaining voltages to 35 V.
In this driver, each channel includes a latch to turn off that
channel if the maximum channel current is exceeded. All
channels are disabled if the thermal shutdown is activated. A
common FAULT output is used to indicate either chip thermal
shutdown or any overcurrent condition.All outputs are enabled
by pulling the common OE/R input high. When OE/¯R is low,
all outputs are inhibited and the eight latches are reset. The
OE/¯R function can be especially important during power-up,
in preventing floating inputs from turning on the outputs.
Under normal operating conditions, each of eight outputs
will source in excess of 100 mA continuously at an ambient
temperature of 25°C and a supply of 35 V. The overcurrent
fault circuit will protect the device from short-circuits to ground
with supply voltages of up to 30 V.
Continued on the next page…
Typical Application
CPU
IN1
IN2
IN3
IN4
IN5
IN6
IN7
IN8
FAULT
OE/R¯
2987
OUT1
OUT2
OUT3
OUT4
OUT5
OUT6
OUT7
OUT8
GND
VS
1 to 8 Load
Components
4.75 to 35 V
29876-DS, Rev. 6
|
|
UDN2987x-6
DABIC-5 8-Channel Source Driver
with Overcurrent Protection
THERMAL CHARACTERISTICS
Characteristics
Symbol
Test Conditions
Package Thermal Resistance*
RθJA Package LW, on 4-layer board based on JEDEC standard
*Additional thermal information is available on the Allegro Web site.
Rating
48
Unit
°C/W
Power Dissipation versus Ambient Temperature
4.0
3.5
3.0
2.5
2.0
(RPQJaAc=ka4g8e
LW
ºC/W)
1.5
1.0
0.5
0
25 50 75 100 125 150
TA (°C)
Allegro MicroSystems, LLC
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
5
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for UDN2987LWTR-6-T electronic component. |
Information | Total 9 Pages | |
Link URL | [ Copy URL to Clipboard ] | |
Download | [ UDN2987LWTR-6-T.PDF Datasheet ] |
Share Link :
Electronic Components Distributor
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
Part Number | Description | MFRS |
UDN2987LWTR-6-T | The function is DABIC-5 8-Channel Source Driver. Allegro Microsystems | |
Semiconductors commonly used in industry:
1N4148 |  
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
UDN2
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA |